Tuesday, June 4, 2013

DIY ESS - Fan holes drilled & spinning test

A bit noisy, all this drilling, but it is done !

First: markings

Second: small holes drilling (2.5mm, easier)

Third: bigger holes (7mm)

A little test with a 12V AGM battery: it blows well, enough to egt all the hot air out when charging or discharging I think; And it is very quiet :-) with or without the doors closed

Two extra holes to put screws to hold the shelf, otherwise it just falls (!)

I bent a little bit the base of the second shelf and put it on top of the bottom metal sheet

Bending on this corner side

No comments:

Post a Comment

Please Share this Post if you Liked it !

Please Share this Post if you Liked it ! Thanks !
Related Posts Plugin for WordPress, Blogger...